Factory for DGX Spark

A 3-tier, 6-node modular factory-building stand for DGX Spark nodes (336 × 160 × 286.5 mm assembled), split into support-free FDM parts ≤ 168 × 160 × 61.5 mm, with a detachable 4-chimney Crown. (1 of 2)

1/2

Multi-tier stand for DGX Spark nodes. Built for engineers running several DGX Spark nodes at once, this three-tier stand holds six units in individual bays, two side by side per level. Open front and rear faces keep cables within reach and let air move straight through each tier during long compute sessions.

Tiers stack and lock together. Each tier is split into matching left and right bay halves that align at the corners with drop-in pegs, then a tie plate spans the underside, its threaded screws biting into heat-set brass inserts to pull the halves tight. Stack tier on tier, then seat the four-stack crown on top to finish the build.

Comments

More like this

buy

Original Medieval-fantasy Wizard Chess Set

buy

Shelf 4 DGX Spark

buy

FitMate: Hands-Free Workout Companion

buy

Rod-Drop Scram Console

A skyline of ports and stacks. The detachable crown carries four hollow chimney flues, each about 1.4 inches across and 2.4 inches tall, rising off a saw-tooth roofline. Riveted panel facades wrap every tier, while open front and rear openings run the full width for cable pass-through and cross-ventilation.

Twenty-eight pieces, three tiers. The stand ships unassembled as 28 printed pieces: left and right tray-and-rim halves for each of the three tiers, two tie plates, twelve matching corner alignment pegs, and the two-piece detachable crown. Every part is sized to print without supports and fits together by hand before final screws.

Comments

Specs.